How do I set up an RS-232 connection to an AudioCodes MP-1xx?
To set up an RS-232 connection to an AudioCodes MP-1xx, take the following steps:
Please note that the RS-232 connection is used for emergency case in order to
The IP address of the MP ant its MAC address.
With a standard RS-232 straight cable (not a cross-over cable) with DB-9 connectors, connect the MP-1xx RS-232 port to either COM1 or COM2 RS-232 communication port on your PC. Create a HyperTerminal connection (you can refer to WindowsTM Online Help (Start>Help)). When prompted, use the following communications port settings:
Baud Rate: 115,200 bps
Data bits: 8
Parity: None
Stop bits: 1
Flow control: Hardware
You should view a screen as displayed in the illustration below.
MAC address = 00-90-8F-01-00-9E
Local IP address = 10.1.37.6
Subnet mask = 255.255.0.0
Default gateway IP address = 10.1.1.5
TFTP server IP address = 10.1.1.167
Boot file name = ram35136.cmp
INI file name = mp108.ini
Call agent IP address = 10.1.1.18
Log server IP address = 0.0.0.0
Full/Half Duplex state = HALF DUPLEX
Flash Software Burning state = OFF
Serial Debug Mode = OFF
Lan Debug Mode = OFF
BootLoad Version 1.75
Starting TFTP download... Done.
MP108 Version 3.80.00
